Now we apply the final profiles and then press CTRL+T to see the tool paths. We have set this to drill straight down and up, without any spiraling. We set the profile for only a single pass which we have set as drill straight. Now we move to the back piece and create a new part for it so it can be run individually if necessary. The ones with an X in them will not actually rout. We will set the feed rate lower on the roughing to offset this. If you want to adjust this you need to set the spacing to at least. You will notice that only the finishing is able to pass through the separation lines. We press CTRL+T to generate the tool paths. Now all lines should be joined and we can do a roughing and finishing profile. This is not done in Inventor so we need to do this in CAMBAM. You will notice that the lines are not joined so we need to join and close the lines. We pick up on part 10 by setting the profile in CAMBAM for roughing and finishing. If you can’t find an answer in this 200-page guide, you can consult the vast archive of the HSM Post-Processor Forum, and even post your question on this very active forum.In the 10th and final part of the series we will be showing the final result from design to fabrication on the CNC machine. However, the good news is that Autodesk publishes a free manual to guide you through the process, covering the basics of JavaScript and explaining the various sections of a post file. There is unfortunately no user interface changes must be made to the code in JavaScript language. It can be opened and edited in Notepad or any other text editor. cps post-processor file is merely a text file. Indeed, the “SolidCAD Universal FANUC” post-processor and all the post-processors available on the HSM Post Library website are unlocked and open-source.Ī post. If you wish to make changes yourself, you are free to do so. If you require other changes, SolidCAD offers a post-processor modification service to adapt this post to your machine and to your best practices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |